Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: Christine88 on August 25, 2016, 09:33:56 PM
-
Has anyone had problems plugging a C25S BOB to the ESS smoothstepper board. It's an excessive tight fit and it won't go all the way down due to the Ethernet housing in the way. I'm thinking now I may need to use a couple 30 pin daisy chain cables.
-
The C25 fitted the ESS just fine but the C25S is not quite correct dimensionally - it sort of fits :)
Tweakie.
-
The C25 fitted the ESS just fine but the C25S is not quite correct dimensionally - it sort of fits :)
Tweakie.
Yeah I figured it was something like that. I'm going to try using two 30 pin computer ribbon cables connect it.