Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Bertho on May 27, 2007, 02:32:01 PM
-
Help!
I just installed the Mach-3 2.0.0065 software and played with it and it looked fine.
I then followed the MicroMill DSL 3000 manual and copied the following files into the Mach-3 folder:
Mach3mill.xml, Mach1lic.dat, MPS1024E.set and the BackgroundToolpath3.jpg into the BitMaps\Millbitmaps folder.
The software runs and I can control the mill so everything appears to function except it looks like the
font is too big and does not fit in the boxes and buttons. The G-Code help screen is unreadable too.
I am using Windows-XP with latest service packs. I tried to change screen resolution but it did not help.
What happened? How do I fix it?
Thanks in advance,
Bertho
-
Can you get any help from the the people that made to screen set ? If not I will see what I can do to help..
Thanks
Brian
-
I also have a DSLS 3000. I have no problem with the button font size if my monitor is at at least 1024x768. However... the G-codes are unreadable. Whats strange is that on a PC with an old flat panel the g-codes look fine. Butt on my new Dell laptop regardless of resolution, adaptor scaling, font size, etc the G-codes are allways unreadable. The A-Z codes just to the left on the same screen are always readable.