Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Thom2000 on August 18, 2016, 05:49:32 PM

Title: Pin-out signal to activate button function
Post by: Thom2000 on August 18, 2016, 05:49:32 PM
Hello Group,
I would like to activate the Single Block button in Mach3 using a 12v input signal.
Is this possible using a brain ?
Thank you in advance.
TC
Title: Re: Pin-out signal to activate button function
Post by: Hood on August 18, 2016, 06:11:49 PM
Is your breakout board/ external controller/ whatever capable of taking 12v?

If it is then yes you can use a brain or you could use the macropump.

Hood