Machsupport Forum
Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: estes53 on August 13, 2016, 09:10:51 PM
-
I got my spindle to turn on via Mach 3, but when it is on Mach 3 thinks it is off and vice versa.
No speed control, seems to be at full speed.
Any ideas?
Thanx, Alan
-
Finally found some instruction for my BOB and got it set up per them.
Now as soon as the BOB receives 5v from the computer, the spindle starts.
I can do spindle calibration as long as Mach 3 agrees that the spindle is running, by tapping start/stop until it recognizes start.
The spindle is continuing to run the whole time.
-
This was a temporary spindle until I could afford something better, so I guess I will just manually control it, which works fine.
The only thing I don't like about that is that the pot that came with it only has about a quarter turn throw, so it may be difficult to get exactly the right speed.