Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: J.Hunter on August 13, 2016, 08:44:58 AM
-
1) Does it work?
2) If it does work, does Constant Velocity work in tangential mode?
3) If (1) and (2) are true, does it work through SmoothStepper?
Currently using Mach3 v3.043.022 - tangential fails in any version newer than that.
-
Brian is working on the tangential stuff right now. CV is working. I don't know the status of the rest of it. But it may do what you need. Try it out and see. It should work with Ethernet Smooth Stepper fine. Or any other motion device that Mach 4 supports.
Steve