Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Dansonn on August 11, 2016, 07:34:32 AM

Title: Coordinates change
Post by: Dansonn on August 11, 2016, 07:34:32 AM

I can't understand this, after completing the gcode for a strategy it obviously returns to home x0,y0,z0. I then load the code for the next strategy which has been created with the exact same setup and run it goes to a slightly different axis than what's in the code. My only thoughts are that the motors have turned on the spindle so Mach thinks it's in a slightly different locations? I know there are times when this would happen but not during these occurrences. Please help.