Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: cncbobuk on August 10, 2016, 10:25:15 AM

Title: Art code 102
Post by: cncbobuk on August 10, 2016, 10:25:15 AM

Hi all, just completed my 2nd router construction and doing some testing, however I'm getting a problem with Mach 3 stopping mid cycle on odd occasions.

The program just hangs and reports "Art Code 102" offers to try to recover, which is not successful then I have to click "no" when Mach 3 closes down.

After restarting all is well again.

Any ideas whats happening?

Mach 3 running on Win 7 laptop and e-cut motion control board.

Title: Re: Art code 102
Post by: cncbobuk on August 17, 2016, 07:38:39 AM

All sorted, simple really I was using the laptop on battery power and the power saving was affecting Mach 3. After plugging it in and setting the power settings to always on everything is fine.