Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: rohitk14 on July 26, 2016, 01:55:27 AM
-
Kindly tell us Mach4 can support full close loop control over axis while motion or only monitor axis if support kindly tell how to configure in mach4.
-
True closed loop support in Mach4 requires an suitable interface
with a plug-in that supports closed loop. Currently I can think of
one example that is actually available:
http://www.vitalsystem.com/portal/motion/dspmc/dspmc.php
-
hi
the csmio/ip-a controller from cs-labs is analog +/- 10v closed loop controller. i believe the other control csmio/ip-s does also but i am sure of the ip-a the only draw back is the plug in for mach 4 isnt as far along as i would like i really like the product but there are a few things in lathe that are not supported yet and it has been quite some time. that being said i am using the controller for my mill upgrades and we shall see when the updated plugin comes out.