Machsupport Forum
Third party software and hardware support forums. => Galil => Topic started by: RockClimb on July 21, 2016, 04:11:10 PM
-
I am new to Mach 3 and I am look for information on setting it up with a Galil board. Is there a how to or tutorial available? This is on an older large format routing table and we are wanting to upgrade the 16 year old software.
-
I have managed to configure the XY & Z axis and they just need some minor tweaking for accuracy and maximum speed. I have not yet been successful in activating the spindle, vacuum table, or misters.
-
My original request a bit over 4 years ago. Due to a lack of support I gutted the system and installed an ESS board and with at the time prototype Gecko Motion Control stepper boards. I left this company over a bit over a year ago, but the system was fully 3D functional.