Machsupport Forum
Third party software and hardware support forums. => CS-Lab => Topic started by: MatttDamon on July 14, 2016, 01:48:24 PM
-
Hey there,
I just finished converting my CNC Mill to a CSMIO-IP/A and began testing with Mach4 only to find that its missing some constant velocity settings. I decided to go back and test with Mach3. Despite showing up on the CSMIO control board as a trigger, one of my limit switches isnt being triggered in the Mach3 diagnostics. I cant for the life of me figure out why this would happen
-
If you attach your xml I will take a look.
Hood
-
the new version of mach4 has cv control