Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: jackson74 on July 11, 2016, 09:35:07 PM

Title: Machine not centering again
Post by: jackson74 on July 11, 2016, 09:35:07 PM
My machine has just never worked correctly, it has always been problems.  I thought this was fixed but now I tried to do a cutout of a 5" by 3" rectangle in a piece of plywood and it is off center by .25" on the length and 3/16" on the width.  Everything is correct in Aspire and looks perfect.  All my measurements are perfect as well.

Any idea why this would all the sudden be off like this?

I just did a complete setup and cleaning of the machine do to other problems (inlays not working) finally after months got inlays working and now back to a simple cutout not centering.

Thanks for any help,