Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: PCH on June 27, 2016, 04:26:52 PM

Title: DRO'S
Post by: PCH on June 27, 2016, 04:26:52 PM

My pc did an upgrade to windows 10 and now dro's show movement but
the cnc does not respond when I jog.
Should I revert back to Windows 7 or is there a fix for Windows 10? :-[

Title: Re: DRO'S
Post by: mc on June 27, 2016, 04:40:11 PM

If you are using the parallel port, then you'll need to revert to Windows 7 (32bit).

If you're using an external motion controller, then you'll need to check you have a signed driver suitable for Windows 10.

Title: Re: DRO'S
Post by: PCH on June 27, 2016, 04:45:11 PM

Just got that figured out.  I did revert back as I do have a parallel port.

thanks for getting back to me