Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Trent Smith on June 10, 2016, 10:59:02 PM

Title: Newbie help with Lazycam_ mach3
Post by: Trent Smith on June 10, 2016, 10:59:02 PM

Hello, I am new to this forum and need some help. I have some basic drawings created using AutoCAD uploaded to Lazycam. The problem I have is there is a unwanted drawing sitting in the Mach3 loader tab of lazycam. I need help to remove this unwanted drawing and load my current project. I hope this is an easy thing to do.
Thanks in advance Trent Smith

Title: Re: Newbie help with Lazycam_ mach3
Post by: RICH on June 11, 2016, 06:11:21 AM

Save your AutoCAD drawing as a version 12 dxf. Use the Open DXf tab to open that drawing or File> Open....

There is a manual for Lazycam in Member's Doc's.

RICH