Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Bob Hepple on May 22, 2007, 01:49:33 PM
-
Hi to the the forum as I am new,
been working with mack 3 for a couple of weeks and had my machine setup tht if I hit the emrgeny stop switch on screen, the z would move to safe height. I set this in config\safe z setup. this used to work but I had a little miss hap(my fault) and when I hit stop nothing happened to the z. any help would be appreciated I am running mach version R2.00.065 hope someone can help.
-
This was fixed off line and the problem was that the tool will not pickup if you hit the reset button... only the stop button.
(Wanted to have this if any other people had the same question ;) )