Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Bill_O on June 02, 2016, 03:10:54 PM
-
Ok I am still using Mach3 Rev 3.042.020
i have used this for some tangential knives in the past and had no problems.
this machine also has an atc on it
just made a simple square.
knife turns correctly for the cuts like normal.
gets to a corner, lifts, rotates, plunges to depth
then as the line is being cut the z also starts plunging
gets to the next corner
lifts, rotates, etc
it is random
sometimes after first rotation, sometimes after second or third
Bill
-
updated to the newest mach 3 and the same thing.
has anyone else seen this?
any suggestions at all?
-
plunges to depth then as the line is being cut the z also starts plunging
Does the Z axis DRO indicate this unwanted plunging during the line cut ?
Tweakie.
-
yes the dro is showing the move
mach is doing the move i just can not understand why
-
here is a link for a video at dropbox
https://www.dropbox.com/s/3u7zygogf5uoq0y/20160603_165651.mp4?dl=0