Machsupport Forum
Third party software and hardware support forums. => PoKeys => Topic started by: GerdS on May 28, 2016, 01:57:42 PM
-
I just updated my controller to new version 4.1.65.
But now the Homing function works not like before.
Unfortunally i killed my X Axis sensor.
It looks like the homing does not stop the motors immediately after the signal comes.
My X home switch is also the end switch therefore i have just a few mm for stop.
After downgrate to an earlier Firmware version all is Ok again.
-
Hi, Gerd
The update 4.1.65 will be pulled and a fix will be released immediately.
-
Ok, fine.
Could you find a solution for the Motion step Overflow issue already. ?
If you need somebody for tests, i can do this for you.
Gerd
-
Unfortunately, we are still working on determining the cause for the steps overflow issue. I think we will have the fix soon.