Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: xb70xb36 on May 21, 2007, 04:13:30 PM

Title: x,y,z zero changes while machine is running program
Post by: xb70xb36 on May 21, 2007, 04:13:30 PM

x,y,z zero changes alot (inches) while machine is running program at or near 100% of set feed speed

g code generated by rhino cam

none of the encoders are loose

any ideas

Title: Re: x,y,z zero changes while machine is running program
Post by: Graham Waterworth on May 21, 2007, 04:28:20 PM

Could be vibration, system noise, bad cables.

Graham.