Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: PCH on May 11, 2016, 02:55:06 PM
-
Got everything hooked for my zero tool plate correctly
went into diagnostics and the digitize light is already on and
I have not made the connection :-\ disconnected wires
from breakout board and still it is on. Restarted Mach and light is
still on. Light should be off normally correct? ???
-
Yes off normally
Is the probe input configured in ports&pins?
-
It is. I have found that if I uncheck active low the light goes out.
The light comes on when I complete the circuit. Now it works. Not sure why
as the video I watched said to put the green check mark for active
low in the ports & pins for the probe.
-
Thats the one :)
Nice one.
-
Hi PCH it depends on what the N.O. state is.