Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: chrsbrbnk on May 11, 2016, 01:56:32 AM

Title: x axis moving in wrong direction and not homing
Post by: chrsbrbnk on May 11, 2016, 01:56:32 AM

I'm using dmm servos and their break out board    z axis and y axis  home and move off the combo limit/home switches, but the x axis just hits the limit switch and trips the limit switch  not working it as a homing switch.  I tried messing about in the home/ limits setup area  and can then get the x to move the right direction  when running a wizard program  but instead of climb milling as programed its conventional milling    thanks,  Chris

Title: Re: x axis moving in wrong direction and not homing
Post by: CES on May 07, 2018, 03:58:17 PM

Check Thank you have Ports and Pins assigned correctly. In my Mill, X is not inverted, Y is inverted and Z is not.