Machsupport Forum

Support => Downloads => Post Processors => Topic started by: JoaoSilva on April 16, 2016, 04:58:31 AM

Title: Mach4 +SheetCam post processor file
Post by: JoaoSilva on April 16, 2016, 04:58:31 AM

Hi all,

Need some support over here. I´m new on this and any help is appreciated.

Building from scratch a plasma CNC using the Hicon 7766 and mach4 SW.

Installed SheetCAM and was asked for the post processor file. I´ve searched without success. Does this file exist? if so can you help me?

Thx, Joao

Title: Re: Mach4 +SheetCam post processor file
Post by: JoaoSilva on April 18, 2016, 11:43:46 AM

Received this info from the SheetCAM  Team. Thx.


The 'Mach3' post should work. If you are plasma cutting use the 'Mach3 plasma' post