Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Marmot_Militia on May 18, 2007, 11:17:15 AM
-
Machinists,
I like to use the conversational machining to make g-codes.Ê When I post a g-code the are saved as "NewProgram.tap".Ê I then change the name to make it memorable.Ê I now have several g-codes and would like to combine them so I don't have to open a new one for each machining sequence.
What's the best way to combine them?Ê cut and paste when "Edit G-code"-ing or is there another way?
Thanks,
MM
ps: found out this forum doesn't like Firefox.
-
You can open them in notepad and edit all you like :D
Hood
-
That is odd I use fire fox all the time
-
Brian, I get the funky garbage-text when I hit return in Firefox (using it now) but it formats correctly in Safari. Oh well, MM