Machsupport Forum
Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: StepDIR on April 06, 2016, 06:33:41 PM
-
I would like to use the Hicon Integra to drive existing +/-10VDC servo amplifiers. Does anyone know of a solution to take step/dir and convert to +/- 10 VDC?
I want to use the Hicon Integra now because I plan to upgrade to AC servo motors in the future.
Thanks,
Jay
-
Hello Jay,
Although the HiCON Integra cannot be used for +/-10V axis control, we do have another motion controller that can.
Here is a link to the DSPMC webpage. It can drive +/-10V (analog), step-dir (digital), and EtherCAT drives. EtherCAT is still in the works though.
http://www.vitalsystem.com/portal/motion/dspmc/dspmc.php
Hope this helps.
-Marc
Vital System Inc.