Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: jguillen on May 18, 2007, 12:38:32 AM
-
Hello All,
Can someone please help. I am not sure what is wrong with my settings. I just installed the most receint version of Mach3(verision .070). When I jog either the x or y axis, the motors move a little then ramp down to a stop then ramp back up to full speed.
This also happens when I run a program. If I disable the back lash the problem goes away. Any Ideas?
Thanks,
Jose.
-
To speed up the time of the backlash correction set your lower your Shuttle time. it is under the General configs .
Thanks
Brian
-
Thanks, I used .01 sec. I just guessed this value. Would you recomend this or a different value? What exactly is this any way?
-
Ths is the time to ramp down the axis for the backlash correction. If you think it can do it faster make it smaller :)