Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Davek0974 on April 03, 2016, 01:11:09 PM
-
On the excellent 2010 scree-set goto zero's button, is it possible to edit the commands ?
I find it does Z first which can be dodgy with fixtures etc in the way, would be good to lift Z then move the X & Y
-
Never had the 2010 screenset but could it be you do not have a safe Z set in Mach?
Hood
-
Possibly, I thought my safe z was zero, will have to check it.
Thanks
-
It uses Mach3's built in Goto Zero function.
If you want to change it, you need to use a screen editor to change the function of the button.
-
Ok, thanks, wasn't sure if it was a macro call.