Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: jimthefish on April 01, 2016, 11:45:44 AM
-
Just got my Mach machine program running on a new computer again but it was pulsing to fast so pressed special driver and got nothing. How do I get back to the original driver. I clicked it but nothing again? Any ideas how to get back to original driver.
-
Sorted. I reloaded the program and the icon reappeared. after testing it. It say "pulsing to fast" is there anyway I can slow it down or is it set by the computer?
-
It actually says "Pulsing too fast"
If you do an advanced search for this there are lots of posts to read (not too read ;-) )