Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: fixittt on May 17, 2007, 04:16:03 PM

Title: get error when trying to CLICK HERE for artcam post processors
Post by: fixittt on May 17, 2007, 04:16:03 PM

I went to look for an Artcam post processor.  Its in the list.  But when I click on the link it gives me an error.


What Im looking for is a 4 axis post processor right now Im using the model master X,Y,A and some things just dont come out right..........

fixittt@yahoo.com


Thanks,
 Robert