Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: ffulmer on March 22, 2016, 03:50:14 PM

Title: Jog dial not working after changing computers????
Post by: ffulmer on March 22, 2016, 03:50:14 PM

Hello:

I had to switch computers and all is fine except my SCR Robotics (ShuttleXpress) Jog Dial is not right. I can move the table in .001 steps but when I turn the dial to rapid nothing happens. When I select X,Y or Z I get a ding and Mach 3 shows the selected direction but no rapid, do I have something turned off?? I have a spare (back-up) but get the same results with both.

Fred