Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: BarryM on March 20, 2016, 07:55:22 AM

Title: Slaving an axis
Post by: BarryM on March 20, 2016, 07:55:22 AM
 I have a 3 axis controller I'm using the X,&Y axis Z is open  I need to slave my x axis can I use the Z axis as the slave?  I went into mach3 to the slave drop down but how do you set up the correct slave?
Title: Re: Slaving an axis
Post by: ger21 on March 20, 2016, 08:23:18 AM
Go into ports and pins and configure the "z axis" on your controller to be the A, B, or C axis.