Machsupport Forum

Third party software and hardware support forums. => Newfangled Solutions Mach3 Wizards => Topic started by: vmax549 on May 16, 2007, 10:13:45 PM

Title: NFW Cut Circle
Post by: vmax549 on May 16, 2007, 10:13:45 PM

ROn the NFW cut circle has gone waky. It is back to cut a small jog outside the circle radius again and also when the cutter reaches 180 deg of the circle it retracts to safe z and takes off at a 45 deg angle atfull speed towards what looked like the "reference" position untill it hits the switches. I caught it before it slamed into the switches. No matter what the settings I used it did the same thing. I also rebooted the computor and still the same. ????

I tried the other cut circle in the wizards by Karin(??) and it worked perfectly, back to the nfw and it did the same thing again???

(;-) TP

Title: Re: NFW Cut Circle
Post by: vmax549 on May 17, 2007, 10:58:44 AM

Problem update:

If I open the wizard and do" not" change the Z depth of steps for cut , it does not take off at the 180 deg point but the little jog inside the circle still remains at the point it starts the arc to cut.

So far I can change any setting but that one and it does not take off at 180deg.

 (;-) Tp

Title: Re: NFW Cut Circle
Post by: vmax549 on May 17, 2007, 04:15:15 PM

Problem update:

Ron, I upgraded to the latest version of Mach and the problem so far has gone away. (;-) TP