Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: katcreek on March 13, 2016, 03:28:08 PM

Title: Load G code
Post by: katcreek on March 13, 2016, 03:28:08 PM

I am trying to load my g code into Mach 3. It won't load any of the file.  I've tried restarting Mach 3 a few times and using files I have used before.  Any suggestions on what could be happening? 

Title: Re: Load G code
Post by: katcreek on March 13, 2016, 03:30:58 PM

OK....I just figured this out.  I could only see stc files not tap.  When I loaded the tap file, the g code loaded.  Sorry about the post.