Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: chada13 on March 13, 2016, 01:56:04 AM
-
Hello again. I've created some g-code and run it in Mach 3 and seems everything is scaled down in size. I have Mach 3 configured to imperial (inches).
I use Inkscape to generate the svg file (in inches). Then I use MakerCAM to create the g-code. The final output should be about 8" x 3". But when I run it through Mach 3, it plots it out in a very small area like 2" x 2" or so. I've tried creating other g-code and they all seem to be scaled down to a very small area also. Did I miss something in my configuration setup?
Thanks in advance!
-
On the Settings page you will find the Axis Calibration feature - use this to check that you have the Steps Per Unit set correctly for each axis.
Tweakie.
-
Thanks for the prompt reply. I will give that a try. Sounds like that will be the fix.
Greatly appreciated! ;D