Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: BarryB on February 21, 2016, 07:43:12 PM
-
Hey folks, I'm having trouble setting my limit switches for the 4th and 5th axis. I had the mill set to use 2-9 on port 2 as inputs, and when I'd set one on 2 it would say it is also striking the other one that's set to 7. If I reversed the settings, the same was true. Then If I instead set to 13 and 15, I couldn't get either to say the limits were being hit. Btw, when I say being hit, I'm just touching the ends of the wires together. I'm not even going through a switch yet. I wanted to make sure they work, before moving on.
Anyway, if you have an idea, let me know. I'm excited to get my mill operational again after a year absence. I knew I needed to rewire it, so I did, and it had shorts due to bad solder. Now that's all fixed, it's almost operational, except for fixing the B/C axis!
Barry