Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: sculler on February 16, 2016, 07:01:03 AM
-
Hi using the jog keys to set an origin on my second hand gerber. I find that the machine continues travelling (decelerating) along the X or Y when I have stopped pressing the arrow keys. How do I stop this happening as it makes setting a consistent origin almost impossible? I have no home switches so cannot us an offset. Many thanks
-
It sounds as though your Acceleration settings are too low (Config / Motor Tuning).
Tweakie.
-
Use MDI to make the machine move where you want it.
Also in the past I've experienced stuck keyboard keys. that's annoying.
-
I agree with Tweakie. Probably room for adjustment there.
You can also use the Jog Increments of 1,.01, .01, ..001 once you get near to your destination.
Russ
-
hi
Many thanks, problem solved