Machsupport Forum
Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: SomeBodyElse on February 11, 2016, 11:47:00 AM
-
Hi,
I was wondering if anyone has found a way of making the VFD TECO 7300CV communicate with mach4
Its connected to my PC over a DB-9 cable, I believe RS-232.
I know the spindle works properly Everything works when I am running my old controller software on the PC, but not yet working in Mach4.
I attached the documents I could find on my VFD. There is all this talk about 232 485 and Modbus and it has me a little confused.
The application is the MicroKinetics Express XL Mill, in case any one is curious.