Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Larry on March 11, 2006, 08:18:26 PM
-
Using Mach 3 I can't get it to turn on tne Mist or Flood relays. I have the proper pin configuration (pin #, Active High on output 1 & 2) on the diagnostics screen, the leds light as they should for outputs 1 and 2, but the port is not sending a high signal to the board. I double checked this with a logic probe -- they stay low even though the leds light up. What am I doing wrong? These functions work OK under MACH2.
-
Have you looked on the "ports & Pins" setup menu? There is a tab that says "Spindle Setup" and you have to uncheck the "disable relay" box and set the output number.
-
Yep - I already did that. They are set to output 1 (Flood), 2 (mist) on pins 14 and 16 respectively. Those are my output relay pins for flood and mist. It doesn't work.
-
The default setting for the port # on the ports & pins output signals tab is port 0- I couldn't get my spindle relay to work until I set it to port #1. Maybe that's it?
-
Larry,
If you don't get it just send me yout XML and I will check it.
-
All,
Thanks much for all the great suggestions. It turned out I had a bad cable. I replaced it and all works fine. I guess I damaged it when I moved my machne a few days ago. Sorry for the false alarm.
-Larry