Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Q Division on February 09, 2016, 10:29:12 AM

Title: Spindle does not run when running G-code but runs when I click the toggle button
Post by: Q Division on February 09, 2016, 10:29:12 AM

Please help.
I've tried known good G-Code that has worked in the past.  Everything appears to work fine except that the M3 command appears to be ignored.
Any ideas?
Thanks,
Neil

Title: Re: Spindle does not run when running G-code but runs when I click the toggle button
Post by: engraversoflight on February 09, 2016, 12:14:46 PM

It happens to me too.  Usually I just shut down the program, restart, and it's good.

Title: Re: Spindle does not run when running G-code but runs when I click the toggle button
Post by: stirling on February 10, 2016, 04:47:42 AM

check your m3 macro isn't corrupt.