Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: avondsf15 on February 08, 2016, 06:30:40 AM

Title: china cnc 6040
Post by: avondsf15 on February 08, 2016, 06:30:40 AM

Having set up Mach 3 and every thing seems to work when using keyboard to move,  I load  a geode  when I start to machine it stops and the motors sound like they are stalling any ideas

Title: Re: china cnc 6040
Post by: Tweakie.CNC on February 08, 2016, 06:42:35 AM

Try reducing your Velocity and Acceleration settings in Motor Tuning by 50% for the X and Y axes, save the changes after altering each axis. If this cures the problem then fine tune your motor settings for optimum performance. The Mach3 manual gives more detailed information http://www.machsupport.com/help-learning/product-manuals/

Tweakie.

Title: Re: china cnc 6040
Post by: avondsf15 on February 08, 2016, 10:27:46 AM

Tried retuning the motors but still stalls when trying a gcode
works up until a geode runs then just stalls

Title: Re: china cnc 6040
Post by: Graham Waterworth on February 08, 2016, 10:39:58 AM

is this a lathe or mill or what, what computer, what hardware, parallel port or motion controller?

 

Title: Re: china cnc 6040
Post by: avondsf15 on February 08, 2016, 10:43:38 AM

the machine is a cnc 6040Z router/mill, Dell XP 32bit computer/ operating through the parallel port