Machsupport Forum
Third party software and hardware support forums. => PoKeys => Topic started by: Dan13 on February 02, 2016, 03:15:09 PM
-
Hi,
Should softlimits work with this setup? I am not able to turn softlimits on in Mach3. Getting the message that I am beyond limits, although I am within the defined envelope.
Thanks,
Dan
-
If you are getting this message, the message is coming from Mach3. Check your settings first (and machine coordinates!).
-
Thanks. Restarting Mach helped solve this. However, still have a problem of the axes not stopping exactly at the defined soft limit, but rather overshooting by an amount depending on the feed rate.
Dan
-
This is how soft limits are implemented in PoKeys device. In Mach4, soft limits are taken over by Mach4 and the axes stop spot on.