Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: N4NV on February 02, 2016, 09:16:09 AM

Title: Touchprobe
Post by: N4NV on February 02, 2016, 09:16:09 AM

Is there a plugin or wizzard for mach 4 that works with a touch probe so that it will automatically find the center of a circle or the edge of a part?

Vince

Title: Re: Touchprobe
Post by: DazTheGas on February 02, 2016, 11:07:08 AM

on the probing screen under bore.

DazTheGas

Title: Re: Touchprobe
Post by: N4NV on February 02, 2016, 11:48:25 AM

That was obvious, sorry about the waste of bandwidth.

Vince