Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Cuemaker on January 16, 2016, 02:41:23 PM

Title: Z TOUCH PLATE WAS WORKING??
Post by: Cuemaker on January 16, 2016, 02:41:23 PM

I found that when I put my grounding wire on the bit it sa my

Title: Re: Z TOUCH PLATE WAS WORKING??
Post by: Cuemaker on January 16, 2016, 02:53:44 PM

I found that when I put my grounding wire on the router bit it says my toolplate is grounded. If I touch my ground wire to the toolplate it acts normal. But touching the toolplate to the router / bit does nothing. Any help.. only thing I have done different is changed routers...

Title: Re: Z TOUCH PLATE WAS WORKING??
Post by: ger21 on January 16, 2016, 04:49:54 PM

Hard to understand by your description, but it sounds like your new router is isolated.

Title: Re: Z TOUCH PLATE WAS WORKING??
Post by: Cuemaker on January 17, 2016, 01:33:47 PM

found bad wire   tks