Machsupport Forum

Mach Discussion => FAQs => Topic started by: carolmiller275 on January 16, 2016, 12:42:42 PM

Title: set delay for spindle spin up
Post by: carolmiller275 on January 16, 2016, 12:42:42 PM

Where in mach3 can you set a delay that delays the g-code from running until the spindle is up to speed. 6 sec or 7 sec , or do you have to do it in the g-code.

Thanks

Title: Re: set delay for spindle spin up
Post by: carolmiller275 on January 16, 2016, 01:43:57 PM

Got it I had tried it before but it didn't seem to work.