Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: jimini on March 09, 2006, 04:19:40 PM
-
How can I change the gauge block offset, or tool offsets to '0'. It is at +7.xx and I can't get it to change, and keep the setting?
It seems to screw up my safe Z movements, I have the safe Z set for 2" and it hits the top stop (no limits yet).Thank You..Jim
-
Type in the value and Press enter :) That is working here ...
-
Stupid me! I must have had a seniors moment (hour) I clicked on the save settings and about every other button I could find, and it always reverted to the original settings.
I sure fee stupid.lol..Thanks for waking me up......Jim
-
No problem I have done it too :o