Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: markseger on January 05, 2016, 06:37:22 AM
-
I am learning every day, Mach 3 is a fool proof program with more features than I will ever use. Question, I run Vectric Aspire, send to mach, I manually turn the router on, run the tool-path, then have to manually turn the router off. How can I set the router to turn off after the tool paths have been run? Im sure its fairly simple, just haven't been able to find it.
-
Check out SuperPID.
http://www.vhipe.com/product-private/SuperPID-Home.htm
Other ways to do it if you just want on and off, as in using a relay, but why not go for RPM control too!
-
I just ordered a solid state relay with 3 -5 volt input
assigned a pin to it. Wired it to 110V with a plug.
Then when I called I believe a m3 it would turn on
and m4 to turn it off. Works great.
olf20 / Bob