Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: alex850 on December 17, 2015, 11:48:45 PM

Title: x key running z motor
Post by: alex850 on December 17, 2015, 11:48:45 PM

My x arrow key is running my z motor.  I had my controller checked to make sure the wires were not backwards, they were right. Need some help on this issue please.

Title: Re: x key running z motor
Post by: cnc many on December 29, 2015, 06:34:15 PM

Check the motor pins  in config config, bet you got them mixed up