Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: AJA on December 14, 2015, 09:45:54 AM
-
I have been asked to make a brand for a logo. How do I change an image into a language that Mach 3 will accept?
This will be done on a vertical mill.
Any help is greatly appreciated.
Thanks
AJ
-
Load it into a CAD program and trace it. Then bring the tracing into a CAM program.
-
My cad will only output a .dwg file. How can I convert that g code? Lazy cam does not work.
-
Most other CAM programs can read a .dwg file.
Are you sure you can't save as a .dxf? Almost every CAD program can.
-
Lazy cam will not read any of the dxf file that I save the cad fill in?
-
Save as the oldest version of .dxf file that you can, preferable v12 or older.
-
I've tried R12 asc II, R14 asc II, R2000-2004, R12,13, and 14 binary among others.
Any other ideas would be appreciated.
-
As far as I know a dxf file is just a text file so open it in notepad and see if you can read it.
I hope this helps Brian
www.ebolt.co.uk