Machsupport Forum

Third party software and hardware support forums. => Modbus => Topic started by: Cncman2nv on December 06, 2015, 10:44:22 PM

Title: Macros Triggered after Part program is regenerated
Post by: Cncman2nv on December 06, 2015, 10:44:22 PM

I'm having trouble finding a solution or a reason why a part program is regenerated in the G code window all the User macros get triggered or ran during the regen process. Ex. An M110 that runs a collect closer M143,M144,M145 that run the Rear spindle. I think it is a serial mod bus issue but not sure looking to see if any one else has had the same issue

Title: Re: Macros Triggered after Part program is regenerated
Post by: Cncman2nv on December 07, 2015, 09:04:18 PM

Problem Solved There is a Tick Box under general config "Ignore M-code when loading"