Machsupport Forum

Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: Toes on December 05, 2015, 02:17:01 AM

Title: Which BOB would you recommend
Post by: Toes on December 05, 2015, 02:17:01 AM

Hi all again I thing I fried my bob it was a v5 of eBay from zentool works anyway have to replace it
Any suggestions on what a good board is for a cnc plasma

Title: Re: Which BOB would you recommend
Post by: Tweakie.CNC on December 05, 2015, 02:22:40 AM

This thread may be of interest to you https://www.machsupport.com/forum/index.php?topic=18214.0

Tweakie.

Title: Re: Which BOB would you recommend
Post by: Toes on December 05, 2015, 03:31:58 AM

Thanks tweakie will check it out