Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: DocNasty on December 02, 2015, 12:35:38 PM

Title: x-Carve Arduino USB w/GShield
Post by: DocNasty on December 02, 2015, 12:35:38 PM

Hey all,

Been on a fun ride this last month, building a CNC, learning Fusion360, Scrapping together a design and then i'm ready to test.  Well, I couldn't get Mach4 to connect to my CNC... I didn't see anything that says Serial port connection.. A little bit of a look around the forums here, and there were only a few recent posts about this.. maybe something about an LUA script, there may at one time been a VB script for Mach3. 

I thought I'd ask for a definitive 'As a Newbie' question. 

Is there any support for the GShield/Arduino/USB connection type CNC Machines, or is there something I need to modify to get it to work with it.

Thanks. 

~D

Title: Re: x-Carve Arduino USB w/GShield
Post by: DazTheGas on December 02, 2015, 01:12:43 PM

Your topic was answered here http://www.machsupport.com/forum/index.php/topic,31072.0.html (http://www.machsupport.com/forum/index.php/topic,31072.0.html)

Daz