Machsupport Forum

General CNC Chat => Building or Buying a Wood routing table.. Beginnners guide.. => Topic started by: dominick_david on November 25, 2015, 11:41:20 AM

Title: new motor
Post by: dominick_david on November 25, 2015, 11:41:20 AM
Hello everyone.
Guys, sorry if my thread is in a wrong subforum
i want to share my problem with you.
I own AXYZ Model 6010 CNC Router. I need to install new motor. Please,  advise me what motor characteristics should I focus on? And where is it better to buy it.
Thanks
Title: Re: new motor
Post by: dominick_david on November 27, 2015, 02:25:32 AM
Bump,
I was googling for the required motor model because the rates from official dealer are very high. Has anybody ordered from this supplier https://www.mrosupply.com/motors/stepper-servo-motors/
I will order it to my home, I worry to get the used motor.