Machsupport Forum
Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: Matt1911 on November 07, 2015, 11:20:06 AM
-
I just updated to version 2 of mach 4. I couldn't figure out how to get my parameters to transfer over so I had to redo everything I took pictures of all my settings before hand and have been through them several times so I don't think it's that.
Anyways M3/M4 won't start my spindle the S**** will sent a frequency command to the vfd but it won't activate the relay to send the Fwd or Rev comand. I can toggle the spindle on and off Fwd or Rev with the buttons in the lower right corner. But it won't do it in mdi or Gcode. Any ideas of things to try? keeping in mind I'm far from a programmer of any sort.
I forgot to include this I updated the firmware on the Hicon it says 3.12 and put the new plug-ins in the plug-ins folder of mach 4 the 10-09-15 ones
-
I'm currently emailing back and forth with vital systems support. Hopefully we will get this figured out soon.